Xtramus NuDC-4U V2.1 Manuel d'utilisateur télécharger pdf (Page 9)

2. DUT Power Status Measurement

The following chapter will guide you with wiring/connecting your DUT with NuDC-4U and performing DUT

power status measurement.

Hardware Installation

There are several accessories provided for the connection to most of DC powered device. Please read

the instruction below.

2.1. Connecting NuDC-4U with PC

Connect USB port of NuDC-4U to PC or external power adaptor. If it is connected to PC, PC can control

and also provides power to the NuDC-4U.

2.2. Connecting NuDC-4U with PCB

Connect USB port of NuDC-4U to PC or external power adaptor. If it is connected to PC, PC can control

and also provides power to the NuDC-4U.

¾ Connection of ground pole

In the design of PCB, it should has ground PIN for the test purpose. All components use the same ground

(negative pole) and all ground conductors are linked together electronically. Connect the ground (negative

pole) to the ground connector of NuDC-4U. Several accessory daughter boards can be soldered on the

same PCB and use the same ground PIN.

¾ Connection of diagnostic channel

There are two conductors inside a channel port. Solder the two conductors (C&B) to the both side (Y&Z)

of the component under test by optional accessories. There is no difference if user swaps the sequence of

wire. For example, solder wire C to Y location and solder wire B to Z location.

ASSY-DC L0805, L1206, and L0603 are mini daughter boards with two soldering conductors for soldering

on PCB (printed circuit board). Two conductors of the accessory can be soldered on the surface of PCB.

The three accessories have different conductor width for testing on PCB with different width of soldering

points.

E-mail: sales@xtramus.com

Website: www.Xtramus.com

XTRAMUS TECHNOLOGIES

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Pas de commentaire

Xtramus NuDC-4U V2.1 Manuel d'utilisateur Page 9