Xtramus DApps-MPT V1.4 Manuel d'utilisateur télécharger pdf (Page 376)

376

E-mail: sales@xtramus.com

Website: www.Xtramus.com

XTRAMUS TECHNOLOGIES

9.4. Test Task – Serial Port (CON)

CON refers to the console port, CON port or RS232 interface. This test will perform a series of standard

terminal command to check the response of CON port. For more detail description regarding to Test

Task – Serial Port, please refer to “5.4. Serial Port (CON) Test”.

9.4.1. CON (Serial Port) – Setup Test

CON (Serial Port) Setup Test executes commands via manual script or script file to DUT’s RS232

interface.

A. Setup

 CON Port Information: This table shows information regarding to the testing serial port.

 Port: CON port of the IPC or the PC that control the chassis

 Baud Rate: Transmission speed.

 Data Bits: Data length of a segment.

 Stop Bits: Stop bits of a segment

 Parity: The method to check the correctness

 Setup: Click this button to set the values on

COM Port Information table. You can click

Default to set all values to default, Apply to apply all the changes you’ve made, or Cancel to exit

without any changes.

 Script Setup: To execute scripts for serial port tests, you can choose to Run Script File, or Run

Script.

 Run Script File: Click Load File to load a text file (*.txt) on your PC.

 Run Script: You can edit/input a script with console commands in the field down below. Click <

Add Waiting to add a waiting command to the edit area. You can set the amount of seconds for

the waiting command in the field down below. To clear all texts in the edit area, click Clear.

 Wait after Setup: You can set the waiting time for the system to halt after finishing configuring.

1 2 ... 371 372 373 374 375 376 377 378 379 380 381 ... 394 395

Pas de commentaire

Xtramus DApps-MPT V1.4 Manuel d'utilisateur Page 376